Plotters
Plotters
(OP)
I was wondering if anyone had any info on a HP DesignJet 750c Plotter. I have one and it keeps cutting off the top and bottom of my prints.
Any info would be greatly appreciated.
Thanks
Chris Tellers
Any info would be greatly appreciated.
Thanks
Chris Tellers






RE: Plotters
Is it cutting them off in the length direction of the roll, or on the sides?
Is this a new problem?
Is it only on certain drawings?
Were there changes made to the Solidworks installation? (update, etc.)
Maybe you need to re-enter your settings.
We really need some more information.
RE: Plotters
Regards,
Scott Baugh, CSWP
3DVision Technologies
www.3dvisiontech.com
www.scottjbaugh.com
FAQ731-376
FAQ559-716 - SW Fora Users
RE: Plotters