Meshing in Pro/Mesh
Meshing in Pro/Mesh
(OP)
Dear Friends
I want to mesh an assembly having 4 -5 components using Pro/Mesh. My Problem is, "there is gap between two components (in microns)".Can i use Gap element type of things in pro/Mesh.
If yes? Then How?
Nikhil Gothankar
I want to mesh an assembly having 4 -5 components using Pro/Mesh. My Problem is, "there is gap between two components (in microns)".Can i use Gap element type of things in pro/Mesh.
If yes? Then How?
Nikhil Gothankar





RE: Meshing in Pro/Mesh