SAE standard replacement
SAE standard replacement
(OP)
Hi folks,
I have a connector and I am looking for the replacement standard for the part in commercial or MIL spec standard, IEEE or any other non SAE standard.
The part numbeer is for a controller area network connector.
SAE J1939/11 (CAN connectors). It is a 3-pin connector plug.
Any info regarding this is greatly appreciated.
Regards
Cancsco
I have a connector and I am looking for the replacement standard for the part in commercial or MIL spec standard, IEEE or any other non SAE standard.
The part numbeer is for a controller area network connector.
SAE J1939/11 (CAN connectors). It is a 3-pin connector plug.
Any info regarding this is greatly appreciated.
Regards
Cancsco





RE: SAE standard replacement
http://www.iso.ch
Regards,
Cory
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.