Exploded View not possible
Exploded View not possible
(OP)
SW03, SP3.1
I have an assembly (228 components, 200 mates) with 3 configs. I can't create an Exploded View in any of the configs. CTRL-Q doesn't help.
Anyone seen this or have advice?
I have an assembly (228 components, 200 mates) with 3 configs. I can't create an Exploded View in any of the configs. CTRL-Q doesn't help.
Anyone seen this or have advice?
"But what... is it good for?"
Engineer at the Advanced Computing Systems Division of IBM, 1968, commenting on the microchip.
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?






RE: Exploded View not possible
Regards,
Scott Baugh, CSWP

MadMango (Mechanical)
(OP)
Weird. I've been doing exploded drawings all week, and this was the first time I experinced this. I tried it on another comp and everything was fine. I went back to my comp and everything is working as it should.
3DVision Technologies
http://www.scottjbaugh.com
Merry Christmas
RE: Exploded View not possible
Chalk up another SW hiccup.
"But what... is it good for?"
Engineer at the Advanced Computing Systems Division of IBM, 1968, commenting on the microchip.
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?