Converting assembly in WF to SolidEdge
Converting assembly in WF to SolidEdge
(OP)
Hello,
I'm currently using ProE Wildfire. I've just completed a large assembly. I would like to covert it so that it can be used by our vendor which uses SolidEdge software. Any suggestions or comments would be appreciated.
Thank You,
Matt
I'm currently using ProE Wildfire. I've just completed a large assembly. I would like to covert it so that it can be used by our vendor which uses SolidEdge software. Any suggestions or comments would be appreciated.
Thank You,
Matt





RE: Converting assembly in WF to SolidEdge
"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
RE: Converting assembly in WF to SolidEdge