STL conversion problem
STL conversion problem
(OP)
When I export a part in eDrawing to stl format and try to open it in sw2004 sp4.1 , sw doesn't response ...
But I can open it in other cad systems.
Anyone has same experience ?
But I can open it in other cad systems.
Anyone has same experience ?






RE: STL conversion problem
SW will open and STL file but it will not have any geometry, just triangular surfacing.
Regards,
Scott Baugh, CSWP
3DVision Technologies
http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376
FAQ559-716 - SW Fora Users
RE: STL conversion problem