new user needs help
new user needs help
(OP)
hi, im a new solidworks user who has just come on board after 10 plus years of cadkey. i can't figure out how to get the bend deductions to work. i model a simple l-bracket at 3" x 3" and then flatten it. we assigned a .114 bend deduction as that is our standard for .048 18 gauge stainless and we get a flat pattern at 6" with no deduction taken. what am i doing wrong?






RE: new user needs help
RE: new user needs help
Regards,
Scott Baugh, CSWP
3DVision Technologies
http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376
FAQ559-716 - SW Fora Users