tube
tube
(OP)
Hi everyone,
I make a hole into a tube (the outside diameter of the tube is 8mm and the inside diam. is 5.5mm), 1mm radius. I want to see the shape of the hole after the tube is flattened. How to do this in UG NX?
Thanks,
alf
I make a hole into a tube (the outside diameter of the tube is 8mm and the inside diam. is 5.5mm), 1mm radius. I want to see the shape of the hole after the tube is flattened. How to do this in UG NX?
Thanks,
alf





RE: tube