Moeller MCC
Moeller MCC
(OP)
Good people,
I am looking for any information or feedback about your experience with Klokner Moeller MCC and contactors.
I have worked with the company in Europe, where it is more well known but have no experience with them in the US.
So if any of you has had experience with them in US, I will appreciate it if you share it with me.
Thanks and regards
Ted
I am looking for any information or feedback about your experience with Klokner Moeller MCC and contactors.
I have worked with the company in Europe, where it is more well known but have no experience with them in the US.
So if any of you has had experience with them in US, I will appreciate it if you share it with me.
Thanks and regards
Ted






RE: Moeller MCC
Their circuit breakers used to have clear covers, which I always liked because I could inspect the contacts. I had a few electricians who didn't like it because they thought it was "wierd" to see the breaker mechanism work. I never understood that sentiment. I am not sure it that is the case any longer, I think Moeller may have succumbed to the pressure to be like everyone else.
The contactors are probably better than most IEC styles, but there again, most are now very good anyway IMHO. Years ago there were some cheap crappy IEC products spit out by small companies and peddled in the US by the likes of Westinghouse, but I think they did it on purpose to highlight how much better their NEMA contactors were. KM was never one of those, they always took the high road of quality and reliability. At one time they published a guarantee that if their contactors wore out prematurely they would replace them for free. I don't know if that is still the case but hey, it is worth asking. The trick is in the selection. If you have a load that has a high duty cycle or long acceleration, make sure you tell them that up front. Theur normal duty cycle was published at 1 million electrical operations (10 million mechanical). 1 million operations is 10+/hr, 24/7/365 for 10 years. I never bought any replacement contacts in the years that I used their gear on projects.
That brings up the main difference between NEMA and IEC design philosophy. IEC requires a little bit of application engineering, NEMA assumes the worst case so you don't need to think about it as much. You can always order an IEC contactor to match a NEMA rating anyway, you will just have to pay the higher price, as you do with NEMA design contactrs. Again, it is an economic choice.
I say if they are offerring a good value and you feel confident in their support, go for it. There is no lack of quality or short cuts taken in their design and manufacturing. The only problem is in that they are not as ubiquitous here in the US as say Allen Bradley or Cutler Hammer. If you have one of their offices close by, no problem. If you are in the middle of nowhere you may have difficulty obtaining replacements or add-on units off the shelf, but with next-day air and instant communications, that is not as much of an issue any longer.
"Venditori de oleum-vipera non vigere excordis populi"
RE: Moeller MCC
You have touched all my concerns about KM in that case.
If it was European project, I wouldn't have had any doubts.
Basically it seems that there might be some compatability and maintenance issues, which I better discuss with my client.
For your information, from what I see the covers are no longer transperant.
Thanks and regards
RE: Moeller MCC
RE: Moeller MCC
RE: Moeller MCC
"Venditori de oleum-vipera non vigere excordis populi"