Input
Input
(OP)
Dear all,
I am running abaqus cae and my model is in "nanometer" scale but I am not sure about the following input:
ELASTICITY = 100E-9 (100 GPa)
LOAD: 1E-12 (1 MPa)
I would be obliged if one can help me.
saeed
I am running abaqus cae and my model is in "nanometer" scale but I am not sure about the following input:
ELASTICITY = 100E-9 (100 GPa)
LOAD: 1E-12 (1 MPa)
I would be obliged if one can help me.
saeed





RE: Input
the values are correct.
For verification it's usefull to scale the mass also and use F=m*a. The unit system has to be consistent.
Hope this helps.
Greetings Tamlin