Projected Geometry
Projected Geometry
(OP)
I am trying to get projected geometry from an unused sketch in the tree, to be visible on a drawing.
I can get the free sketch lines to come through using "Get Model Sketches" But only true lines come in, it seems to ignore projected geometry.
Is it a case where I need to over draw to make them drive to the drawing?
I can get the free sketch lines to come through using "Get Model Sketches" But only true lines come in, it seems to ignore projected geometry.
Is it a case where I need to over draw to make them drive to the drawing?





RE: Projected Geometry
Sean Dotson, PE
www.sdotson.com
www.mCADForums.com/forums
CAD Professionals & Consultants Discussion