Extremely small end mills
Extremely small end mills
(OP)
Get a load of this. End mills under .0005 diameter!
http://www.pmtnow.com/
http://www.pmtnow.com/
Manufacturing Freeware and Shareware
http://mrainey.freeservers.com





RE: Extremely small end mills
That 0.0004 end mill blows my mind!!!!!!
Mrainey,
I use your ME Consultant software and it is very good. Thanks you for doing all that hard work and then sharing it for free.
RE: Extremely small end mills
Manufacturing Freeware and Shareware
http://mrainey.freeservers.com