Disappearing centrelines
Disappearing centrelines
(OP)
I have a drawing of a bent tube when I insert a horizontal brake in section view the centrelines disappear
Anyone seen this happen and if so have you got a fix?
I am on SW04 SP3 have tried it on another machine with SW04 SP2.1
Thanks
Jim
Anyone seen this happen and if so have you got a fix?
I am on SW04 SP3 have tried it on another machine with SW04 SP2.1
Thanks
Jim






RE: Disappearing centrelines
Regards,
Scott Baugh, CSWP
http://www.3dvisiontech.com
http://www.scottjbaugh.com
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
RE: Disappearing centrelines