Copying components in an assembly
Copying components in an assembly
(OP)
I have an assembly in Solidworks 2003. I need to copy a group of about 20 components to the side of this original group. I want an exact copy with all the components oriented the same. Is mirror/copy the best route to do this? I read in the archives that mirror/copy sometimes causes problems. Having the copied parts linked to the original is favorable in my design, because any change to the original needs to apply to the copy. Thanks.






RE: Copying components in an assembly
RE: Copying components in an assembly
RE: Copying components in an assembly
RE: Copying components in an assembly
RE: Copying components in an assembly
So, the linear pattern works for components in an assembly? I have never tried it, but if I can pick all the components and then move them all to the right 6 inches, it will work for me.
RE: Copying components in an assembly