Human Modeler in NX 2.0.4
Human Modeler in NX 2.0.4
(OP)
Greetings!
I am looking through the "What's new guide in NX 2.0.4" and noticed that the recent release has incorporated a "Human Modeler".
Supposedly, the tool is located under:
Modeling-> Tools-> Human Modeling-> Create Human
However, I do not see this tool in my pull-down menu. Does anyone else?
Is this an "add-on" feature for UG that we must buy, or is this a feature that we must activate in a file somewhere?
I am looking through the "What's new guide in NX 2.0.4" and noticed that the recent release has incorporated a "Human Modeler".
Supposedly, the tool is located under:
Modeling-> Tools-> Human Modeling-> Create Human
However, I do not see this tool in my pull-down menu. Does anyone else?
Is this an "add-on" feature for UG that we must buy, or is this a feature that we must activate in a file somewhere?
Regards,
Grant
Aerospace Engineer





RE: Human Modeler in NX 2.0.4
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
RE: Human Modeler in NX 2.0.4
Have you used this module? We have needed this capability for quite a while, but want something that is halfway realistic.
So if the module spits out a half-way attractive human, it may be worth the money.
Regards,
Grant
Aerospace Engineer
RE: Human Modeler in NX 2.0.4
It's called Jack & your UGS Sales Rep. can give you more detailed information on cost, etc. unless Ben has some experience with it.
Tim Flater
Senior Designer
Enkei America, Inc.
www.enkei.com
RE: Human Modeler in NX 2.0.4
We have a simple 95% man that we use for layout positioning.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
RE: Human Modeler in NX 2.0.4
I asked GTAC the same question and got this reply:
The release notes are wrong this functionality is not due until version 3.0.1 or possibly 2.0.5.2 if they get it ready in time!
Regards
Simon C
RE: Human Modeler in NX 2.0.4
Did they give any indication whether this would be an included feature in NX or will this functionality be an add-on as Ben is indicating?
Regards,
Grant
Aerospace Engineer