Solidworks 2001 plus question
Solidworks 2001 plus question
(OP)
Hello everyone !
Has someone heard of a problem with Solidworks 2001 plus and a helical groove made by cut sweep, the groove actually ends beyond the end of helix by a few degrees. Now when done in Solidworks 2004, this problem is not there?
Please do let me know if you have heard of such a problem.
Regards
Vik
Has someone heard of a problem with Solidworks 2001 plus and a helical groove made by cut sweep, the groove actually ends beyond the end of helix by a few degrees. Now when done in Solidworks 2004, this problem is not there?
Please do let me know if you have heard of such a problem.
Regards
Vik






RE: Solidworks 2001 plus question
I'll let other people tell you more about it, since I haven't used SW2001+ for a few years now.
Cyril Guichard
Mechanical Engineer
RE: Solidworks 2001 plus question