×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Table Curve

Table Curve

Table Curve

(OP)
I've created a group of 38 table curves in an attempt to easily create a lofted protrusion of a ship's hull.  the curves are all parallel to each other.  However, when I go to the lofted protrusion command it will not accept the input from a table curve.  any suggestions on how to do this without tracing each curve into a sketch??

RE: Table Curve


You may want to use the 'Curve by Table' command to create the curves. You can use these curves as cross sections for BlueSurf or Lofted Surface commands. After creating the surface, use 'Thicken' command to create a solid.

HTH.

Regards

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources