endless cube
endless cube
(OP)
Hi you!
this is my first entry and I am really helpless. I hope that maybe one of you can help me.
In my simulation there is a small cube, which is one part of a big work piece, but I hve no clue how I can "say" ansys that the front area is not the end of the cube. in my calculations the temperature and the residual stress should move ยด"through" the areas.
Do somebody know the command for my problem?
it would be great. thanks a lot!
Nele
this is my first entry and I am really helpless. I hope that maybe one of you can help me.
In my simulation there is a small cube, which is one part of a big work piece, but I hve no clue how I can "say" ansys that the front area is not the end of the cube. in my calculations the temperature and the residual stress should move ยด"through" the areas.
Do somebody know the command for my problem?
it would be great. thanks a lot!
Nele





RE: endless cube
Maybe You could use symmetry boundary conditions to let ansys know that the cube does not end at one face.
harry