Stubborn sketcher dimensions
Stubborn sketcher dimensions
(OP)
We are using 2001.
We are noticing that sometimes when in sketcher modifying a dimension to a whole number sketcher will regenrate and display the dimension in funny number; eg. say the dim was 1.00 this will be displayed as 0.99999995.
I have tried different methods, it works fine when deliberately I chose the edge to dimension to rather than the surface.
Does anyone have this problem?
We are noticing that sometimes when in sketcher modifying a dimension to a whole number sketcher will regenrate and display the dimension in funny number; eg. say the dim was 1.00 this will be displayed as 0.99999995.
I have tried different methods, it works fine when deliberately I chose the edge to dimension to rather than the surface.
Does anyone have this problem?
Joe Borg
www.methode-eur.com





RE: Stubborn sketcher dimensions