UG/Hole Table
UG/Hole Table
(OP)
I currently use an old grip program to list x & y locations of holes in a chart. Unfortunately the values are not associated with the geometry.
Somehow I stumbled on a Swiss EDS site that uses UGopen API execute to create a chart, dimension the holes in the chart and are associated with one another.
I have emailed several times but have never received any response. Is anybody familiar with such an application? It looks like a powerful tool.
Here is the link to the info about ug/hole table.
http://www.ugs.ch/n02/n06lokalappl/Unigraphics/pdf/LAP11010_20_UGCAD_UGHoleTable_EN_v02.pdf
Thanks in advance.
Somehow I stumbled on a Swiss EDS site that uses UGopen API execute to create a chart, dimension the holes in the chart and are associated with one another.
I have emailed several times but have never received any response. Is anybody familiar with such an application? It looks like a powerful tool.
Here is the link to the info about ug/hole table.
http://www.ugs.ch/n02/n06lokalappl/Unigraphics/pdf/LAP11010_20_UGCAD_UGHoleTable_EN_v02.pdf
Thanks in advance.
Wayne Huseby
Drafter/Checker
Goodrich Corp
Jamestown, ND 58401
701-253-7799




