Wall Design in ETABS
Wall Design in ETABS
(OP)
Can anybody explain how to model a wall (such as bearing walls which are also shear walls and subject to transverse bending loads) subject to axial, lateral and transverse loads, analze and design in ETABS





RE: Wall Design in ETABS
u can draw it as shell elements then assign it as piers and select the design case ( T-c, uniform, general ) section.
there is a very useful video tutorials in CSI home page
http://www.csiberkeley.com/support_watch&learn.html
and sure the Etabs manuals has an expatiation discription about modeling and design shear walls
regards