Note Symbols
Note Symbols
(OP)
Hello,
I was wondering if can modify frames around the note symbols. If any can point me where the code is, I can go in and modify it.
See link for an example:
http://groups.msn.com/MAI-Engineering/shoebox.msnw?action=ShowPhoto&PhotoID=2
Thanks,
I was wondering if can modify frames around the note symbols. If any can point me where the code is, I can go in and modify it.
See link for an example:
http://groups.msn.com/MAI-Engineering/shoebox.msnw?action=ShowPhoto&PhotoID=2
Thanks,
Macduff
Meggitt Airdynamics Inc.






RE: Note Symbols
Thread559-42918
Ray Reynolds
"Computers in the future may weigh no more than 1.5 tons."
Popular Mechanics, forecasting the relentless march of science, 1949
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?
RE: Note Symbols
Regards,
Scott Baugh, CSWP
http://www.3dvisiontech.com
http://www.scottjbaugh.com
If you are in the SW Forum Check out the FAQ section
To make the Best of Eng-Tips Forums FAQ731-376
RE: Note Symbols
MadMango's link to the thread helped me out. I spent about 2-1/2 hours yesterday adjusting the code in Gtol.sym file.
See Link for example:
http://www.msnusers.com/MAI-Engineering/shoebox.msnw?action=ShowPhoto&PhotoID=3
Look at difference in the frames.
Macduff
Meggitt Airdynamics Inc.