Loaded documents
Loaded documents
(OP)
I have been designing in a fresh CATPart, nipping backwards and forwrads into other "reference" CATParts, for measurements, taking dump sections etc.
If I close these "reference" CATParts without saving the changes, and try to re-open (to give me a fresh model), catia gives me an warning to say that this model is already loaded in the current session and then re-opens it as it was closed, with all the junk I had created but chose not to save!
Does any body know of anyway around this?
If I close these "reference" CATParts without saving the changes, and try to re-open (to give me a fresh model), catia gives me an warning to say that this model is already loaded in the current session and then re-opens it as it was closed, with all the junk I had created but chose not to save!
Does any body know of anyway around this?





RE: Loaded documents
RE: Loaded documents
CATIA seems to save these parts in memory so that they load faster when you try to re-load them later. It would be nice if it would give you the option to revert the part to the "as filed" condition when you re-read it, just like MS Word does.
RE: Loaded documents
I suggested to Dassault to bulid in a simular function to ProENGINNERS "Erase all not shown" (Erase all documnets in memory except the active one). This was in R9 and I havn't heard anything yet.
Anyone how knows if DS is working on anything like this??
RE: Loaded documents